of circumcision - without surgery!The VacuTrac
Penile Enhancement Device
The most sophisticated foreskin restoration product to date.
Instructions for Use
The VacuTrac comes with application instructions when you purchase the product.
Below are additional instructions that are intended to clarify how to use the device for:
foreskin restoration as well as girth enhancement and length enhancement.
FORESKIN RESTORATION:
1. Before using the VacuTrac, liberally apply lotion to the penis (unscented Curél recommended).2. In a standing position, hold the clear plastic VacuTrac tube in one hand and insert the head of the penis into the cup of the latex receiving sheath.
3. With one hand, hold the piston in place. With the other hand, hold the clear plastic cylinder and pull it towards your body allowing the entire penis to enter the tube and engorge (become fatter).
4. Push the piston back into the tube slightly to release a small amount of vacuum pressure, then simultaneously pull both the piston and tube halfway down the length of the penis (away from your body), to the point where the "O" rings on the neck of the latex sheath are at the mid-shaft of the penis.
5. DO NOT PULL any loose penile skin back out of the tube. Make sure as much penile shaft skin as possible is inside the tube before proceeding to the next step.
6. With one hand holding the piston in place, use the other hand to pull the clear plastic tube toward the body to increase the vacuum pressure slightly as necessary.
7. Remain in a standing position with the device in place for no more than 4 to 7 minutes at a time, once or twice a day. CAUTION: While wearing the device, you should feel the strain of the device pulling on the penis, but you should not feel pain. If you feel pain, remove the device immediately. If you begin to see small red pin pricks of blood under the skin, remove the VacuTrac immediately (Step 8), as this is a sign that small blood vessels under the skin are breaking from the vacuum pressure. Always err on the side of caution!
8. To remove the VacuTrac, push the piston back into the tube (toward the body) to release the vacuum pressure and remove penis from the device.
GIRTH ENHANCEMENT:
1. Before using the VacuTrac, liberally apply lotion to the penis (unscented Curél recommended).2. In a standing position, hold the clear plastic VacuTrac tube in one hand and insert the head of the penis into the cup of the latex receiving sheath.
3. With one hand, hold the piston in place. With the other hand, hold the clear plastic cylinder and pull it towards your body while allowing the entire penis to enter the tube and engorge (become fatter).
4. With the penis engorged, wear the VacuTrac in a sitting, reclining or standing position. Do not wear for more than 4-7 minutes. CAUTION: While wearing the device, you should feel the strain of the device pulling on the penis, but you should not feel pain. If you feel pain, remove the device immediately. If you begin to see small red pin pricks of blood under the skin, remove the VacuTrac immediately (Step 8), as this is a sign that small blood vessels under the skin are breaking from the vacuum pressure. Always err on the side of caution!
5. To remove the VacuTrac, push the piston back into the tube (toward the body) to release the vacuum pressure and remove penis from the device.
LENGTH ENHANCEMENT:
1. Before using the VacuTrac, liberally apply lotion to the penis (unscented Curél recommended).2. In a standing position, hold the clear plastic VacuTrac tube in one hand and insert the head of the penis into the cup of the latex receiving sheath.
3. With one hand, hold the piston in place. With the other hand, hold the clear plastic cylinder and pull it towards your body, allowing the entire penis to enter the tube and engorge (become fatter).
4. Pull the tube and piston down at the same time (away from your body) to the point where the "O" rings on the neck of the latex sheath are behind your coronal sulcus (the groove behind the head of the penis).
5. Pull the penile skin back toward the body (using a tissue if necessary) so that no loose skin is in the tube.
6. With one hand holding the piston in place, use the other hand to pull the clear plastic tube toward the body to increase the vacuum pressure slightly as necessary, while not allowing the entire penis to enter the cylinder.
7. Remain in a standing position with the device in place for no more than 4 to 7 minutes at a time, once or twice a day. CAUTION: While wearing the device, you should feel the strain of the device pulling on the penis, but you should not feel pain. If you feel pain, remove the device immediately. If you begin to see small red pin pricks of blood under the skin, remove the VacuTrac immediately (Step 8), as this is a sign that small blood vessels under the skin are breaking from the vacuum pressure. Always err on the side of caution!
8. To remove the VacuTrac, push the piston back into the tube (toward the body) to release the vacuum pressure and remove penis from the device.
Back to U.S. Order Page